Replacement Of No. 1 Idler Gear Bushing - Mitsubishi 6M60-TL Service Manual

Replacement of No. 1 idler gear bushing

[Removal]
[Installation]
• Place the No. 1 idler gear as shown in the illustration. Using
, insert the bushing until
edge of the gear.
• After installation, measure the clearance again.
• If the measurement is less than the standard value, ream the
bushing.
Inspection: Clearance between No. 2 idler gear bushing and
No. 2 idler shaft
[Inspection]
• If the measurement exceeds the limit, replace the bushing.
Replacement of No. 2 idler gear bushing
[Removal]
[Installation]
• Place the No. 2 idler gear as shown in the illustration. Using
, insert the bushing until
edge of the gear.
• After installation, measure the clearance again.
• If the measurement is less than the standard value, ream the
bushing.
11
contacts the chamfered tooth
contacts the chamfered tooth
11-65