Mitsubishi 6M60-TL Service Manual page 144

[Installation]
• Clean the surface of the fuel filter head where the O-ring is to be
mounted.
• Replace the filter element and O-rings with new parts.
• Apply a thin coat of engine oil to the O-rings. Install the O-rings
onto the case and water separator sensor.
CAUTION
• The use of non-genuine filter elements will lead to engine
problems. Be sure to use only genuine parts.
• To help prevent fuel injection problems, keep the fuel filter
and hoses free from contamination.
• Using , tighten the case to the specified torque.
• Tighten the water separator sensor to the specified torque. With
the sensor correctly installed, bleed air from the fuel system.
• Start the engine and ensure that there is no fuel leakage.
• If there is fuel leakage, remove and install the fuel filter correctly.
13A
13A-11