Inspection: Tension Of V-Belts - Mitsubishi 6M60-TL Service Manual

Service standards (Units: mm)
Location
1 V-belt tension
Tightening torque (Unit: N·m {kgf·m})
Mark
Grease nipple
Straight joint
Tube
Clamp
Lubricant and/or sealant
Mark
Grease nipple
Special tools
Mark
Belt tension gauge
Inspection procedure
Maintenance item
Parts to be tightened
Points of application
Tool name and shape
• Press each V-belt at a central portion between pulleys with a
• Place the small O-ring on
• Place the large O-ring on
Service standard
10 to 15
Tightening torque
12.5 ± 2.5 {1.3 ± 0.3}
2.25 ± 0.25 {0.2 ± 0.03}
Specified lubricant and/or sealant
Wheel bearing grease
[NLGI No. 2 (Li soap)]
Part No.
MH062345

Inspection: Tension of V-belts

force of approximately 98 N {10 kgf} as shown in the illustration
and measure the amount of deflection of the belt.
A: Alternator pulley
B: Water pump pulley
C: Crankshaft pulley
to 98N {10 kgf} (press force).
to the maximum permissible deflection value specified for the
belt.
Limit
–
39 {0.4}
As required
Application
Measurement of tension of V-belt
at the scale mark corresponding
at the scale mark corresponding
14
Remedy
Adjust
Remarks
–
–
Quantity
14-25