Alignment Mark; Turbocharger - Mitsubishi 6M60-TL Service Manual

TURBOCHARGER

Turbocharger
Service standards (Unit: mm)
Location
Play in axial direction of shaft
Cartridge
Play
8
assembly
perpendicular to
axis of shaft
Tightening torque (Unit: N·m {kgf·m})
Mark
Bolt (coupling tightening)
Lubricant and/or sealant
Mark
Thread of bolts
O-ring
Work before removal
15-10
Maintenance item
Turbine wheel end
Compressor wheel end
Parts to be tightened
Points of application
• Put alignment marks on the coupling, turbine housing, compres-
Follow the disassembly sequence in re-
verse.
CAUTION
• The cartridge assembly cannot be taken
Standard value
0.05 to 0.09
0.40 to 0.53
0.55 to 0.66
Tightening torque
3.9 to 4.9 {0.4 to 0.5}
Specified lubricant and/or sealant
Molybdenum disulfide grease
[NLGI No. 2 (Li soap)]

Alignment mark

sor cover and cartridge assembly.
Disassembly sequence
1 Hose
2 Actuator
3 Coupling
4 Turbine housing
5 Snap ring
6 Compressor cover
7 O-ring
8 Cartridge assembly
: Non-reusable parts
Assembly sequence
to pieces. Replace the whole assembly if
the turbine wheel or compressor cover is
damaged and when the cartridge does
not rotate smoothly.
Limit
0.1
0.58
0.72
Engine oil
Remedy
Replace
Replace
Replace
Remarks
Wet
Quantity
As required
As required