Panasonic VF0 Series Instruction Manual page 33

Setting functions during operation
●
The motor and motor load fluctuation could change significantly and the motor
may suddenly start or stop when data is being changed during operation.
(Before making changes, ensure personal safety at all times.)
Failure to do so could lead to injury.
[Parameters that can be changed during operation]
Parameter P01, P02
Parameter P05, P42
Parameter P29 to P31 : Jog frequency, acceleration/deceleration time
Parameter P32 to P38 : Preset frequency 2 to 8
Parameter P39, P40
Parameter P56, P57
Parameter P59
Parameter P61
Parameter P64
Note) 0V stop may occur if the "preset frequency 2 to 8 is set to 000", the
Downloaded from www.Manualslib.com
: 1st acceleration/deceleration time
: Torque boost level/2nd torque Boost level
: 2nd acceleration/deceleration time
: Bias/Gain frequency
: Analog, PWM output compensation
: Line speed multiplier
: Carrier frequency
"bias frequency is set to 0Hz or less" or the "gain frequency is set to
000".
(When changing the above data or changing to the above data, the
motor will start and stop simultaneously with the setting of the data, so
always ensure surrounding safety.)
manuals search engine
CAUTION
32