Panasonic VF0 Series Instruction Manual page 29

Operating with the operation panel - 3
● ● ● ●
· Forward/reverse run operation:
· Frequency setting: Digital setting (Parameter P09=1)
Power ON
Frequency
setting
Run
commnad
Changing
the
fre-quency
during
operation
Stop
command
[Changing the frequency with the
(MOP function)]
The operating frequency can be changed with the
operation.
· If the
· If the
Note)
Downloaded from www.Manualslib.com
[Example for rotating in forward direction at operating frequency 25Hz]
The main display lamp will turn ON.
MODE Press the MODE button.
SET Press the SET button. (The main display will flicker)
Press the
the main display.
(The main display will flicker)
Press the SET button to set the data.
SET
Press the RUN button. The factory setting is forward run, so
RUN
the motor will start rotating in the forward direction, and will
reach 25Hz operation in approx. 2.5 seconds.
[Example for rotating in forward direction at operating frequency 50Hz]
MODE Press the MODE button.
SET Press the SET button. (The main display will flicker)
Press the
the main display.
(The main display will flicker)
SET Press the SET button to set the data.
The display will change to the output frequency, and will reach
50Hz in approx. 2.5 seconds.
[Stopping operation]
Press the STOP button.
STOP
The motor will start to decelerate and will stop in approx. 5
seconds.
(up) button is held down, the operating frequency will increase.
(down) button is held down, the operating frequency will
decrease.
Once the operating frequency is determined, press the MODE
button and then press the SET button twice to set the operating
frequency.
If this is not carried out, this frequency will not be saved when the
power is turned OFF.
manuals search engine
Start/stop, rotation direction mode setting
(Parameter P08=0)
(up) and (down) buttons to display 25Hz on
(up) and (down) buttons to display 50Hz on
and
Main display
0
0
2
0
2
2
5
5
0
buttons during operation
and buttons during
0 0
F r
0. 5
5. 0
0 0
5. 0
Ｆ ｒ
5. 0
0. 0
0. 0
0 0
28