Panasonic VF0 Series Instruction Manual page 17

Explanation of operation panel
▲ ▲ ▲ ▲ (up) button
▼ ▼ ▼ ▼ (down) button
Frequency setting dial
[Handling when output current is displayed]
1) The displayed output current is not intended for precise measurement.
2) A relatively large value may be displayed especially at approx. 40% or
Downloaded from www.Manualslib.com
Main display
Mode button
Set button
Frequency
setting dial
The output frequency, current, line speed, error details, data for function
Main display
setting and parameter numbers are displayed.
Run button
This switch is used to start the inverter.
Stop button
This switch is used to stop the inverter.
This switch is used to change to each "output frequency, current display",
Mode button
"frequency setting, monitor", "rotation direction setting" and "function setting"
mode, and to switch the display from the data to mode display.
This switch is used to change the display between the parameter No. and
data display, and to save the data.
Set button
In the "output frequency, current display mode", this switch changes the
display between the frequency and current.
This switch is used to change the data and output frequency, and to set
forward run direction when carrying out forward rotation with the operation
panel.
This switch is used to change the data and output frequency, and to set
reverse run direction when carrying out reverse rotation with the operation
panel.
This is the dial for the potentiometer used to set the operating frequency with
the operation panel.
Use this only as a guide value. (Use a separate measuring instrument
when precise values are required.)
less of the rated current. (For example, even if there is no output current,
a certain level may be displayed. Note that when the inverter is stopped,
"0A" will be displayed.)
manuals search engine
⋅
Hz
▲
MODE RUN
▼
SET STOP
▲ button
Run button
Stop button
▼ button
16