System Exclusive Messages - Roland XV-5080. Owner's Manual

Panpot (Controller number 10)
Status 2nd byte
BnH 0AH
n = MIDI channel number:0H - FH (Ch.1 - 16)
vv = Panpot: 00H - 40H - 7FH (Left - Center - Right),
Initial value = 40H (Center)
Portamento (Controller number 65)
Status 2nd byte
BnH 41H
n = MIDI channel number:0H - FH (Ch.1 - 16)
vv = Control value: 00H - 7FH (0 - 127) 0 - 63 = OFF, 64 - 127 = ON
Resonance (Controller number 71)
Status 2nd byte
BnH 47H
n = MIDI channel number:0H - FH (Ch.1 - 16)
vv= Resonance value (relative change):00H - 7FH (-64 - 0 - +63)
Release Time (Controller number 72)
Status 2nd byte
BnH 48H
n = MIDI channel number:0H - FH (Ch.1 - 16)
vv = Release Time value (relative change):00H - 7FH (-64 - 0 - +63)
Attack time (Controller number 73)
Status 2nd byte
BnH 49H
n = MIDI channel number:0H - FH (Ch.1 - 16)
vv = Attack time value (relative change):00H - 7FH (-64 - 0 - +63)
Cutoff (Controller number 74)
Status 2nd byte
BnH 4AH
n = MIDI channel number:0H - FH (Ch.1 - 16)
vv = Cutoff value (relative change):00H - 7FH (-64 - 0 - +63)
Decay Time (Controller number 75)
Status 2nd byte
BnH 4BH
n = MIDI channel number:0H - FH (Ch.1 - 16)
vv = Decay Time value (relative change):00H - 7FH (-64 - 0 - +63)
Vibrato Rate (Controller number 76)
Status 2nd byte
BnH 4CH
n = MIDI channel number:0H - FH (Ch.1 - 16)
vv = Vibrato Rate value (relative change):00H - 7FH (-64 - 0 - +63)
Vibrato Depth (Controller number 77)
Status 2nd byte
BnH 4DH
n = MIDI channel number:0H - FH (Ch.1 - 16)
vv = Vibrato Depth Value (relative change):00H - 7FH (-64 - 0 - +63)
Vibrato Delay (Controller number 78)
Status 2nd byte
BnH 4EH
n = MIDI channel number:0H - FH (Ch.1 - 16)
vv = Vibrato Delay value (relative change):00H - 7FH (-64 - 0 - +63)
Effect 1 (Reverb Send Level) (Controller number 91)
Status 2nd byte
BnH 5BH
n = MIDI channel number:0H - FH (Ch.1 - 16)
vv = Reverb Send Level:00H - 7FH (0 - 127)
Effect 3 (Chorus Send Level) (Controller number 93)
Status 2nd byte
BnH 5DH
n = MIDI channel number:0H - FH (Ch.1 - 16)
vv = Chorus Send Level:00H - 7FH (0 - 127)
3rd byte
vvH
3rd byte
vvH
3rd byte
vvH
3rd byte
vvH
3rd byte
vvH
3rd byte
vvH
3rd byte
vvH
3rd byte
vvH
3rd byte
vvH
3rd byte
vvH
3rd byte
vvH
3rd byte
vvH
MIDI Implementation
RPN MSB/LSB (Controller number 100, 101)
Status 2nd byte
BnH 65H
BnH 64H
n = MIDI channel number:0H - FH (Ch.1 - 16)
mm = upper byte (MSB) of parameter number specified by RPN
ll = lower byte (LSB) of parameter number specified by RPN
<<< RPN >>>
Control Changes include RPN (Registered Parameter Numbers), which are extended
When using RPNs, first the RPN (Controller numbers 100 and 101; they can be sent in any
This device receives the following RPNs.
RPN Data entry
MSB, LSB MSB, LSB
00H, 00H mmH, llH
mm:
ll:
Up to 2 octave can be specified in semitone steps.
* In Performance mode, the Part Pitch Bend Range parameter
(PERFORM/PART) will change.
00H, 01H mmH, llH
mm, ll:
* In Performance mode, the Part Fine Tune parameter (PERFORM/
PART) will change.
00H, 02H mmH, llH
mm:
ll:
* In Performance mode, the Part Coarse Tune parameter (PERFORM/
PART) will change.
7FH, 7FH ---, ---
RPN and NRPN will be set as "unspecified". Once this setting has been
made, subsequent
Parameter values that were previously set will not change.
mm, ll: ignored
Program Change
Status 2nd byte
CnH ppH
n = MIDI channel number:0H - FH (Ch.1 - 16)
pp = Program number:00H - 7FH (prog.1 - prog.128)

System Exclusive messages

Universal Non-realtime System Exclusive Message" and Data Set 1 (DT1) are the only
System Exclusive messages transmitted by the XV-5080.
Universal Non-realtime System Exclusive Message
Identity Reply Message
Receiving Identity Request Message, the XV-5080 send this message.
Status Data byte
F0H 7EH, dev, 06H, 02H, 41H, 10H, 01H, 00H, F7H
00H, 00H, 00H, 00H, 00H
Byte Explanation
FOH Exclusive status
7EH ID number (Universal Non-realtime Message)
dev Device ID (use the same as the device ID of Roland)
06H Sub ID#1 (General Information)
02H Sub ID#2 (Identity Reply)
41H ID number (Roland)
10H 01H Device family code
00H 00H Device family number code
00H 00H 00H 00H Software revision level
F7H EOX (End of Exclusive)
3rd byte
mmH
llH
Notes
Pitch Bend Sensitivity
00H - 18H (0 - 24 semitones)
ignored (processed as 00H)
Master Fine Tuning
20 00H - 40 00H - 60 00H (-8192*50/8192 - 0 -
+8192 *50/8192 cent)
Master Coarse Tuning
10H - 40H - 70H (-48 - 0 - +48 semitones)
ignored (processed as 00H)
RPN null
Status
289