Roland XV-5080. Owner's Manual page 118

Chapter 3 Selecting Output Jacks
Reverb Send Level
Range: 0–127
Sets the amount of the Chorus unit's output to be sent to the
Reverb. Its final output destination is determined by the
Reverb output setting.
Reverb Output Assign
Range: A–D
Selects the OUTPUT jacks to which the Reverb unit's stereo
output is routed.
* As the internal effects processors are in stereo, settings for the
INDIVIDUAL OUTPUT jacks are unavailable.
SYSTEM Output page ([SYSTEM] - [F2
(OutP&EQ)])
Output Mix/Parallel
Mode
Available Settings:
MIX: Signals that are set to be output from jacks other than
the A (MIX) OUTPUT jacks are mixed and output from the A
(MIX) OUTPUT jacks. This setting allows you to quickly
route everything through headphones when you are creating
sounds, or to combine all of your sounds into two outputs
when sending the XV-5080's signal to a mixer that has only
two channels.
When MIX is selected, sounds routed to the INDIVIDUAL
OUTPUT 3/5/7 jacks are sent to the left A (MIX) OUTPUT
jack, and sounds routed to the INDIVIDUAL OUTPUT 4/6/
8 jacks are sent to the right A (MIX) OUTPUT jack.
PARALLEL: Sounds are routed to output jacks according to
their output settings.
The XV-5080's Master Level and Mix/Parallel settings are
each established using a single global parameter.
SYSTEM General #1 page ([SYSTEM] -
[F1 (General)])
Master
Level (Master Level)
Range: 0–127
Adjusts the volume of the entire XV-5080.
118