Making Multi-Effects Settings; Making Chorus Settings - Roland XV-5080. Owner's Manual

Chapter 2 Using the XV-5080 Effects
Dry Send Level
Range: 0–127
This sets the level of the signal sent to the output destination
set with Output Assign.
Chorus Send Level 0–127
Sets how much of the Tone is sent to the Chorus.
Reverb Send Level 0–127
Sets how much of the Tone is sent to the Reverb.

Making Multi-Effects Settings

This page allows you to establish various settings for the
Multi-effects processor, including its parameters and output-
jack assignment.
On the Effects General page, set the following parameters.
MFX Type (Multi-effects Type)
Use this parameter to select from among the 90 available
Multi-effects. For a description of these effects, check out
"Parameters for Each Multi-Effect (MFX TYPE)" (p. 41).
MFX Dry Send Level 0–127
Determines the level of the Multi-effects processor's output
to the OUTPUT jacks.
MFX Chorus Send Level 0–127
Determines the level of the post-Multi-effects processor
signal sent to Chorus.
MFX Reverb Send Level 0–127
Determines the level of the post-Multi-effects processor
signal sent to Reverb.
MFX Output Assign A–D
Specifies the OUTPUT jacks to which the signal, after it has
passed through the Multi-effects, is to be routed.
Pressing [F2 (MFX Prm)] in the Effects General page calls up
the MFX Param page, in which you can make the following
settings.
MFX A–D Parameter
These parameters allow you to customize the selected Multi-
Effect. For a description of the parameters, check out
"Parameters for Each Multi-Effect (MFX TYPE)" (p. 41).
26
Pressing [F3 (MFX Ctl)] in the Effects General page calls up
the MFX Control page, in which you can make the following
settings.
MFX Control 1–4 Source
Select the Control Source to be used for changing the Multi-
effects parameters, and set the Sens and parameters to be
changed by that Control Source.
OFF: No controller is used.
CC01–95: Controller numbers 1–95 (except for 32)
PITCH BEND: Pitch Bend
AFTERTOUCH: Aftertouch
SYS-CTRL 1–4: System control 1–4
MFX Control Destination 1–4
Selects the Multi-effects parameter to be controlled using the
MFX Control 1–4 source. The parameters that can be selected
depend on which type of Multi-effects is set to MFX Type.
MFX Control 1–4 Sens -63– +63
If you wish to modify the selected parameter in a positive (+)
direction—i.e., a higher value, toward the right, or faster,
etc.—from its current setting, select a positive (+) value. If
you wish to modify the selected parameter in a negative (-)
direction—i.e., a lower value, toward the left, or slower,
etc.—from its current setting, select a negative (-) value.
Higher numbers produce a greater amount of change.

Making Chorus Settings

The XV-5080's Chorus effect unit can also be used as a stereo
delay unit.
These settings allow you to select chorus or delay, the
characteristics of the selected effect type, and the Chorus
output routing.
On the Effects General page, set the following parameters.
Chorus Type
0 (Off): Neither Chorus or Delay is used.
1 (Chrus): Chorus is used.
2 (Delay): Delay is used.
Chorus Output Select
This parameter allows you to send the Chorus output
directly to the currently selected OUTPUT jacks, to the
Reverb, or to both.
MAIN: The Chorus output is sent only to the OUTPUT jacks.
fig.02-009.e
OUTPUT