Roland XV-5080. Owner's Manual page 234

Troubleshooting
the power in the proper sequence. If the device is still not
being recognized, even with the setting at the maximum
value, then that SCSI device cannot be used with the XV-
5080.
Is any SCSI ID being used for more
than one device?
• If more than one device shares the same SCSI ID, then
connected devices will not be correctly recognized.
Follow the procedure described on p. 185 to set the SCSI
IDs so that none is shared by any other device.
Commercial sampler data for other
devices cannot be loaded.
• The XV-5080 is capable of loading S-700 Series and AKAI
S-1000/3000 data. Other formats are not compatible.
Please confirm the compatibility of any commercial data
CD-ROM or other media you are using.
• AKAI S-1000/3000 data is converted when loaded to the
XV-5080. There may be differences in the data compared
to when it is played on the AKAI S-1000/3000.
There is no sound from the digital out,
or there is noise.
• The XV-5080's digital out is not compatible with
sampling frequencies (word clock) other than 44.1 or 48
kHz. When using the XV-5080 with the digital outs
synchronized to an external device, check the sampling
frequency (word clock) of the external device.
• When the sampling frequency (word clock) of the XV-
5080's digital outs is synchronized to an external device,
noise can sometimes be introduced as a result of the
manner in which the cables carrying the signal have
been run. Consequently, noise can be added to the audio
signal, or in some cases, sound may not be heard. In such
instances, you may be able to alleviate problems by
rearranging the cables used to connect the devices.
234