Roland XV-5080. Owner's Manual page 66

Chapter 2 Using the XV-5080 Effects
Depth (LFO Depth)
Adjust the modulation depth of the flanger sound.
Fbk #
Adjust the proportion (%) of the flanger sound that is to be
returned to the input. Positive (+) settings will return the
signal to the input with the original phase, while negative (-)
settings produce an inverted phase. Higher settings will
produce a more distinctive sound.
Phase
Adjust the spaciousness of the flanger sound.
Filter
Type
OFF:A filter will not be used.
LPF:he frequency region above the Cutoff Freq setting will
be cut.
HPF:The frequency region below the Cutoff Freq setting will
be cut.
Cutoff (Cutoff Frequency)
Sets the cutoff frequency when a specific frequency band is
cut off by a filter.
Step Rate
Switch
This setting determines whether the pitch is changed in a
stepped fashion (ON) or not (OFF).
Rate (Step Rate) #
Adjust the frequency of pitch change.
Keysync
Switch (Keysync Switch)
Determines whether the Flanger LFO is reset according to the
input sound (ON) or not (OFF).
Thre (Keysync Threshold)
Adjust the volume level for which reset will be applied.
Thres (Keysync Thres)
Sets the LFO phase when the LFO is reset.
Phase (Keysync Phase)
Sets the LFO phase when the LFO is reset.
66
EQ Gain
Low (Low Gain)
Adjust the low frequency range gain (amount of boost or
cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
High (High Gain)
Adjust the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Balance
Balance #
Adjusts the volume balance between the direct sound and
the flanger sound.
With a setting of D100:0W only the direct sound will be
output, and with a setting of D0:100W only the flanger sound
will be output.
Output
Level (Output Level) 0–127
Adjust the output level.
43:FORMANT FILTER
This adds a vowel character to the sound, making it similar
to a human voice.
L in
Overdrive
Formant
R in
Overdrive
Switch
Determines whether the Overdrive is reset according to the
input sound (ON) or not (OFF).
Drive
Turns Drive on/off.
Specifies the depth of distortion. The volume will change
together with the degree of distortion.
Filter
Vowel 1, 2
Selects the vowel. The left setting is the vowel 1. The right
L out
Pan L
2-Band
EQ
Pan R
R out