Amp Simulator - Roland XV-5080. Owner's Manual

Roland owner's manual 128-voice 8x expansion/sample playback xv-5080
Hide thumbs Also See for XV-5080.:
Table of Contents

Advertisement

Chapter 2 Using the XV-5080 Effects
1: STEREO EQ (Stereo Equalizer)
This is a four-band stereo equalizer (low, mid x 2, high).
fig.2-04
L in
4-Band EQ
R in
4-Band EQ
Freq/Gain
LowFreq (Low Frequency)
Select the frequency of the low range (200 Hz/400 Hz).
LowGain
Adjust the gain of the low frequency.
Mid1 Freq (Middle 1 Frequency)
Adjust the frequency of Middle 1 (mid range).
Mid1 Gain (Middle1 Gain)
Adjust the gain for the area specified by the Middle 1
Frequency and Q settings.
Mid2 Freq (Middle 2 Frequency)
Adjust the frequency of Middle 2 (mid range).
Mid2 Gain (Middle 2 Gain)
Adjust the gain for the area specified by the Middle 2
Frequency and Q settings.
High Freq (High Frequency)
Select the frequency of the high range (4000 Hz/8000 Hz).
High Gain
Adjust the gain of the high frequency.
Band Width
Mid1 Q (Middle 1 Q)
This parameter adjusts the width of the area around the
Middle 1 Frequency that will be affected by the Gain setting.
Higher values of Q will result in a narrower area being
affected.
Mid2 Q (Middle 2 Q)
This parameter adjusts the width of the area around the
Middle 2 Frequency that will be affected by the Gain setting.
Higher values of Q will result in a narrower area being
affected.
44
L out
R out
Output
Level (Output Level) #
Adjust the output level.
2: OVERDRIVE
This effect creates a soft distortion similar to that produced
by vacuum tube amplifiers.
fig.2-05
L in
Over
Amp
drive
Simulator
R in
Overdrive
Drive #
Adjust the degree of distortion. The volume will change
together with the degree of distortion.

Amp Simulator

Type (Amp Simulator Type)
Select the type of guitar amp.
SMALL:small amp
BUILT-IN:single-unit type amp
2-STACK:large double stack amp
3-STACK:large triple stack amp
EQ Gain
Low (Low Gain)
Adjust the gain of the low frequency range.
High (High Gain)
Adjust the gain of the high frequency range.
Output
Level (Output Level)
Adjust the output level.
Pan (Output Pan) #
Adjust the stereo location of the output sound. L64 is far left,
0 is center, and 63R is far right.
L out
Pan L
2-Band
EQ
Pan R
R out

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents