Setting The Tuning And Volume Settings; Setting The System Tempo - Roland XV-5080. Owner's Manual

Setting the Tuning and Volume
Settings
Master
The Master Tune and Master Key Shift settings are common
to all Patches, Performances, Rhythm Sets, and the GM
Mode.
Level (Master Level)
Range: 0–127
Adjusts the volume of the entire XV-5080.
Tune (Master Tune)
Range: 415.3–466.2 kHz
Adjusts the overall tuning of the XV-5080. The setting is
expressed as the frequency played by the A4 key.
Key Shift (Master Key Shift)
Range: -24– +24
Shifts the overall pitch of the XV-5080 in semitone steps.
* When a Multi-partial Patch or Rhythm Set is selected, this
setting is disabled.

Setting the System Tempo

System Tempo
Clock Source (System Clock Source)
Specifies the tempo clock of the system.
Available Settings:
INT: The internal clock will be the tempo clock for the
system.
MIDI: An external clock will be the tempo clock for the
system.
Tempo (System Tempo)
Range: 20–250
Sets the system tempo.
* When Clock Source is set to "MIDI," the tempo will
synchronize to the clock messages received from an external
MIDI device, so the tempo value will be ignored.
Chapter 9 Other Settings/Status Checks
Making Scale Tune Settings
([SYSTEM/UTILITY] - [F1
(General)])
fig.09-002.e_70
Scale Tune
The XV-5080 allows you to use temperaments other than
equal temperament. The pitch of each note can be adjusted in
one-cent steps (1/100th of a semitone) relative to its equal-
tempered pitch.
One set of Scale Tune settings can be created in Patch mode.
In Performance mode and GM system mode, each Part can
have its own Scale Tune settings.
* The selected scale applies to MIDI messages received from an
external MIDI device as well as to local sound generation.
Switch (Scale Tune Switch)
Turn this on when you wish to use a tuning scale other than
equal temperament.
Patch Scale C–B
Range: -64– +63
Key Scale C–B
Range: -64– +63
The Settings in Patch Mode (Patch
Scale)
* The Patch's scale tune settings share the same settings as those
for Part 1 of the Performance.
1. Press [PATCH], getting its indicator to light.
2. Press [SYSTEM/UTILITY], and confirm that its indicator
has lighted.
* If the indicator is blinking, you are in UTILITY mode. Press
[SYSTEM/UTILITY] once again to get the indicator to light
steadily.
3. Press [F1 (General)] several times to call up the SYSTEM
General #2 page.
4. Press [
]/[ ]/[
the note name you want to set.
]/[ ] to move the cursor to
209