Roland XV-5080. Owner's Manual page 146

Chapter 4 Creating Patches
Fade (LFO Fade)
Mode (LFO Fade Mode)
Sets how the LFO will be applied.
Available Settings:
ON-IN: The LFO will fade in after the key is pressed.
fig.04-051.e
Delay
high (more)
Time
WG Pitch /
TVF Cutoff Frequency /
TVA Level / TVA Pan
key is
pressed
low (less)
ON-OUT: The LFO will be immediately applied when the
key is pressed, and will then fade out.
fig.04-052.e
high (more)
WG Pitch /
TVF Cutoff Frequency /
TVA Level / TVA Pan
key is
pressed
low (less)
OFF-IN: The LFO will fade in after the key is released.
fig.04-053.e
high (more)
WG Pitch /
TVF Cutoff Frequency /
TVA Level / TVA Pan
key is
pressed
low (less)
OFF-OUT: The LFO will be immediately applied when the
key is pressed, and will begin fading out when the key is
released.
fig.04-054.e
high (more)
WG Pitch /
TVF Cutoff Frequency /
key is
TVA Level / TVA Pan
pressed
low (less)
Time (LFO Fade Time)
Range: 0–127
This adjusts the time over which the LFO rises to its full
effect or fades away. (Refer to the diagrams for Fade Mode.)
Key Sync (LFO Key Sync)
Range: OFF/ON
Specifies whether you want the LFO cycle to start in sync
with the timing of a key press (ON), or not (OFF).
146
Fade
Time
Depth
Delay Time Fade Time
Depth
Delay Fade
Time Time
Depth
key is
released
Delay Fade
Time Time
Depth
key is
released
Depth (LFO Depth)
Pitch (Pitch LFO Depth)
Range: -63– +63
Adjusts how much the LFO will affect the WG Pitch.
TVF (TVF LFO Depth)
Range: -63– +63
Adjusts how much the LFO will affect the Tone's TVF cutoff
frequency.
TVA (TVA LFO Depth)
Range: -63– +63
Adjusts how much the LFO will affect the Tone's TVA Level.
Pan (Pan LFO Depth)
Range: -63– +63
Adjusts how much the LFO will affect the Tone's TVA Pan.
PATCH LFO&Ctrl #1/#2 page ([PATCH]
- [F5 (LFO&Ctl)] - [F3 (Control)])
fig.04-055.e_70
Matrix Control 1–4
Source (Matrix Control Source)
Assign one of the following controllers to Matrix Control
Source. If you wish to use a controller that will apply to all
Patches, or a controller that cannot be directly selected here,
select SYS-CTRL1–4, and then select the controller using the
System Control Source parameters (System Control Screen).
Available Settings:
OFF: No controller is used.
CC01–CC95: Controller numbers 1–95 (except for 32)
PITCH BEND: Pitch Bend
AFTERTOUCH: Aftertouch
SYS-CTRL1: System controller 1
SYS-CTRL2: System controller 2
SYS-CTRL3: System controller 3
SYS-CTRL4: System controller 4
VELOCITY: Velocity
KEYFOLLOW: Keyfollow
TEMPO: Tempo
LFO1
LFO2