Roland XV-5080. Owner's Manual page 139

Depth (Pitch Envelope Depth)
Range: -12– +12
Determines the amount of pitch enveloping to be used.
Higher values will cause greater change. Negative (-) settings
invert the direction of the changes made by the Pitch
Envelope.
Time Keyfollow (Pitch Envelope Time
Keyfollow)
Range: -100– +100
Use this parameter when you want the keyboard location of
notes to affect times T2–T4 of the pitch envelope. Higher
settings of this parameter will cause greater time change
relative to the envelope time at middle C (C4). Positive (+)
settings cause the times to shorten as you play above Middle
C. Negative (-) settings will extend time.
Time (Pitch Envelope Time 1–4)
Range: 0–127
These settings determine the times over which the basic pitch
settings will change from one pitch envelope level (L1–L4) to
the next.
Level (Pitch Envelope Level 0–4)
Range: -63– +63
Each pitch envelope level value determines an amount of
change to be applied to the Tone's basic pitch.
Velocity Sens (Pitch Envelope Velocity
Sensitivity)
Amount (Pitch Envelope Time Amount
Sensitivity)
Range: -63– +63
Adjust this parameter when you want your keyboard
playing dynamics (velocity) to affect the amount of pitch
enveloping. For higher settings, there will be a greater
difference between softly and strongly played notes.
Negative (-) values invert the change.
Time1 (Pitch Envelope Time 1 Velocity
Sensitivity)
Range: -63– +63
Use this parameter when you want keyboard playing
dynamics (velocity) to affect T1 (Time 1) of the pitch
envelope. For higher settings, there will be a greater
difference between softly and strongly played notes. With
positive (+) settings, greater keyboard velocity will reduce
the T1 setting. With negative (-) settings, greater keyboard
velocity will increase the T1 setting.
Chapter 4 Creating Patches
Time4 (Pitch Envelope Time 4 Velocity
Sensitivity)
Range: -63– +63
Use this parameter when you want keyboard playing
dynamics (velocity) to affect T4 (Time 4) of the pitch
envelope. With higher settings, the T4 value will change
more significantly depending on whether you release the key
slowly or quickly. With positive (+) settings, greater
keyboard velocity will reduce the T4 setting. With negative (-
) settings, greater keyboard velocity will increase the T4
setting.
PATCH WG Sample page ([PATCH] -
[F2 (WG)] - [F4 (Sample)])
You can edit the Sample loaded into the SIMM (memory
module).
* These settings cannot be made unless a sample is being used.
fig.04-041.e_70
Sample
Sampling Freq. (Sampling Frequency)
Displays the original sampling frequency of the loaded
Sample.
Original Key
Set the Note Number for the pitch used for playing the
sample when it was sampled.
Loop
Mode (Loop Mode)
Displays the loop mode of the loaded Sample.
Available Settings:
FWD (Forward):
After the sample played back from the Start point to the
Loop End point, it will then be repeatedly played back in the
forward direction, from the Loop Start point to the Loop End
point.
ONE-SHOT:
The sample will be played back only once, from the Start
point to the Loop End point.
ALT (Alternate):
When the sample has been played back from the Start point
to the Loop End point, playback will repeat to the Loop Start
139