Roland XV-5080. Owner's Manual page 96

Chapter 2 Using the XV-5080 Effects
Amp Simulator
Amp Type (Amp Simulator Type)
Selects the type of guitar amp.
Small: small amp
BltIn: built-in type amp
2-Stk: large double stack amp
3-Stk: large triple stack amp
Delay
Left Time (Delay Time Left)
Adjust the delay time from the original sound until the left
delay sound is heard.
Right Time (Delay Time Right)
Adjust the delay time from the direct sound until the right
delay sound is heard.
Feedback (Delay Feedback Level)
Adjusts the proportion (%) of the delay sound that is fed
back into the delay input.
HF Damp
Adjusts the frequency above which sound fed back to the
effect will be cut. If you do not want to damp the high
frequencies, set this parameter to BYPASS.
Balance (Delay Balance) #
Adjusts the volume balance between the direct sound and
the delay sound.
Chorus/Flanger
Type
Selects either Chorus or Flanger.
Rate
Specifies the rate of modulation.
Depth
Specifies the depth of modulation.
Feedback (CF Feedback)
Adjusts the proportion (%) of the flanger sound that is fed
back into the effect. Negative (-) settings will invert the
phase.
Pre Delay (Chorus/Flanger Pre Delay Time)
Adjusts the delay time from the direct sound until when the
chorus sound is heard.
96
Balance #
Adjusts the volume balance between the direct sound and
the chorus/flanger sound.
Filter
Type
Selects the type of filter.
OFF: No filter is used.
LPF: The frequency region above the Cutoff Freq setting will
be cut.
HPF: The frequency region below the Cutoff Freq setting will
be cut.
Cutoff (Cutoff Frequency)
Sets the cutoff frequency when a specific frequency band is
cut off by a filter.
Output
Level (Output Level)
Adjusts the output level.
Pan (Output Pan) #
Adjusts the stereo location of the output sound.
82: GUITAR MULTI B
Guitar Multi 2 provides Compressor (Cmp), Overdrive or
Distortion (ODDS), Amp Simulator (Amp), Equalizer (EQ),
and Chorus or Flanger (CF) effects connected in series.
fig.02-082m.e
L in
Compressor
R in
Chorus/
3-Band EQ
Flanger
Sequence
Comp (Compressor Switch)
Turns the Compressor on/off.
OD/Dist (OD/Dist Switch)
Turns Overdrive or Distortion on/off.
Overdrive/
Amp
Distortion
Simulator
L out
R out