Routing Tones To Effects; Making Multi-Effects Settings - Roland XV-5080. Owner's Manual

Routing Tones to Effects

This sets the output destination and level for the currently
selected Tone, as well as its send level with respect to the
Chorus and Reverb.
On the Effects General page, set the following parameters.
Rhythm Tone Output Assign
MFX: The Tone is sent into the Multi-effects. Its output
destination is determined by the Multi-effects output
settings.
A–D: The Tone is sent to one of the four output-jack stereo
pairs, OUTPUTS A–D.
1–8: The Tone is sent to the INDIVIDUAL output jacks 1–8.
Rhythm Tone Dry Send Level
Range: 0–127
This sets the level of the signal sent to the output destination
set with Rhythm Output Assign.
Rhythm Tone Chorus Send Level 0–127
Sets how much of the Tone is sent to the Chorus.
Rhythm Tone Reverb Send Level 0–127
Sets how much of the Tone is sent to the Reverb.

Making Multi-Effects Settings

This page allows you to make various settings for the Multi-
effects, including the type, the parameters, and the output
assignments
On the Effects General page, set the following parameters.
MFX Type (Multi-effects Type)
Use this parameter to select from among the 90 available
Multi-effects. For a description of these effects, check out
"Parameters for Each Multi-Effect (MFX TYPE)" (p. 41).
MFX Dry Send Level 0–127
Determines the level of the signal that is to be sent to the
output jacks, after passing through the Multi-effects.
MFX Chorus Send Level 0–127
Determines the level of the signal that is to be sent to Chorus,
after passing through the Multi-effects.
MFX Reverb Send Level 0–127
Determines the level of the signal that is to be sent to Reverb,
after passing through the Multi-effects.
Chapter 2 Using the XV-5080 Effects
MFX Output Assign A–D
Specifies the OUTPUT jacks to which the signal, after it has
passed through the Multi-effects, is to be routed.
Pressing [F2 (MFX Prm)] in the Effects General page calls up
the MFX Param page, in which you can make the following
settings.
MFX A–C Parameters
These parameters allow you to customize the selected Multi-
Effect. For a description of the parameters, check out
"Parameters for Each Multi-Effect (MFX TYPE)" (p. 41).
Pressing [F3 (MFX Ctl)] in the Effects General page calls up
the MFX Control page, in which you can make the following
settings.
MFX Control 1–4 Source
Select the Control Source to be used for changing the Multi-
effects parameters, and set the Sens and parameters to be
changed by that Control Source.
OFF: No controller is used.
CC01–95: Controller numbers 1–95 (except for 32)
PITCH BEND: Pitch Bend
AFTERTOUCH: Aftertouch
SYS-CTRL 1–4: System control 1–4
MFX Control Destination 1–4
Selects the Multi-effects parameter to be controlled using the
MFX Control 1–4 source. The parameters that can be selected
depend on which type of Multi-effects is set to MFX Type.
MFX Control 1–4 Sens -63– +63
If you wish to modify the selected parameter in a positive (+)
direction—i.e., a higher value, toward the right, or faster,
etc.—from its current setting, select a positive (+) value. If
you wish to modify the selected parameter in a negative (-)
direction—i.e., a lower value, toward the left, or slower,
etc.—from its current setting, select a negative (-) value.
Higher numbers produce a greater amount of change.
37