Mitsubishi Electric FR-F820-00046 Instruction Manual page 554

 Writing parameter settings stored in the operation panel to the inverter
Operating procedure
1.
Connect the operation panel to the destination inverter.
2.
Selecting the parameter setting mode
Press to choose the parameter setting mode. (The parameter number read previously appears.)
3.
Selecting the parameter
Turn to "
" " appears.
4.
Selecting parameter write
Turn to change the set value to "
appears.
5.
Writing to the inverter
Press to start writing the parameter settings stored in the operation panel to the inverter. (It takes about 60
seconds to write all the settings. During writing, "
● Perform this step while the inverter is stopped. (Parameter settings cannot be copied during operation.)
6.
End of copying
" " and "
7.
When parameters are written to the destination inverter, reset the inverter before operation by, for example, turning
the power supply OFF.
NOTE
• " " appears when a parameter write error occurred. Perform the operation from step 3 again.
• " " and "
lower or FR-F840-01800(55K) or lower inverters and the FR-F820-03160(75K) or higher or FR-F840-01800(75K) or higher
inverters. When CP and 0.00 are displayed alternately, set Pr.989 Parameter copy alarm release as shown below (initial
value).
Pr.989 setting
10
100
After setting Pr.989, perform setting of Pr.9, Pr.30, Pr.51, Pr.56, Pr.57, Pr.72, Pr.80, Pr.82, Pr.90 to Pr.94, Pr.453, Pr.455,
Pr.458 to Pr.462, Pr.557, Pr.859, Pr.860, and Pr.893 again.
" (Parameter copy) and press
", then press
" are displayed alternately after copying ends.
" are displayed alternately when parameter copy is performed between the FR-F820-02330(55K) or
Cancels the warning of FR-F820-02330(55K) or lower and FR-F840-01160(55K) or lower.
Cancels the warning of FR-F820-03160(75K) or higher and FR-F840-01800(75K) or higher.
.
.
" blinks.)
Operation
5.15 Copying and verifying parameters on the operation panel
1
2
3
4
5
6
7
8
9
10
553
5. PARAMETERS