Mitsubishi Electric FR-F820-00046 Instruction Manual page 228

NOTE
• Under induction motor control (under V/F control or Advanced magnetic flux vector control), the output starts at the frequency
set in Pr.13. Under PM motor control, the output always starts at 0.01 Hz.
• The inverter does not start if the frequency setting signal has a value lower than that of Pr.13. For example, while Pr.13 = 20
Hz, the inverter output starts when the frequency setting signal reaches 20 Hz.
CAUTION
• Note that when Pr.13 is set to a value equal to or lower than Pr.2 Minimum frequency, simply turning ON the start signal
runs the motor at the frequency set in Pr.2 even if the command frequency is not given.
Parameters referred to
Pr.2 Minimum frequencypage 271
Pr.7 Acceleration timepage 216
5.5 (F) Setting of acceleration/deceleration time and acceleration/deceleration pattern
1
2
3
4
5
6
7
8
9
10
227
5. PARAMETERS