Lan Board - Agilent Technologies 1100 Series Service Manual

LAN Board

The HP JetDirect cards are network interface cards used in HP printers.
One board is required per Agilent 1100 stack. It is recommended to add the LAN board to
NO TE
the detector with highest data rate.
The LAN board can only be used together with:
NO TE
a main board version G13XX-66520 (DAD/MWD/VWD/Pump/ALS) or
G13XX-66500 (FLD/RID) and above.
an Agilent-ChemStation software revision A.06.01 or above.
The following cards can be used with the Agilent 1100 modules.
Table 49
Agilent Order Number
J4106A
J4105A
J4100A
Minimum firmware of the JetDirect cards is A.05.05.
NO TE
Recommended Cables
For point to point connection (not using a network hub) use a twisted pair
cross over LAN cable (P/N 5183-4649, 10 feet long).
For standard network connections using a hub use category 5 UTP cables,
(P/N G1530-61480, 8 m long).
1100 Series Nano Pump Service Manual
LAN Boards
Supported networks
Ethernet/802.3, RJ-45 (10Base-T(
Token Ring/802.5, DB9, RJ-45 (10Base-T)
Fast Ethernet, Ethernet/802.3, RJ-45 (10/100Base-TX) + BNC
(10Base2)
Introduction to the Nano Pump 5
217