Overview - Omron G9SP-N20S Operation Manuals

Overview

8-1 Overview
Basic Procedure to Prepare for Operation
132
The configuration data that was created in SECTION 6 Creating Configuration
Data is downloaded to the G9SP-series Controller. The G9SP-series Control-
ler is then changed to RUN Mode so that the operation of the G9SP System
can be verified.
The G9SP Configurator is connected online to the G9SP-series Controller to
download the data, change to RUN Mode, and verify operation.
Basically, preparations for operation with the G9SP-series Controller are per-
formed with the following procedure.
1. Connect the G9SP Configurator online to the G9SP-series Controller.
2. Download the configuration data to the G9SP-series Controller.
3. Verify the configuration data.
4. Change to RUN Mode. (Refer to SECTION 9 Operation and Operating
Modes.)
5. Check operating status and debugging. (Refer to SECTION 10 Checking
Operating Status and Debugging.)
6. Perform safety validation testing (user testing). (Refer to SECTION 10
Checking Operating Status and Debugging.)
7. Lock the configuration data. (Refer to SECTION 9 Operation and Operat-
ing Modes.)
This section describes steps 1 to 3, as well as the following online operations.
■ Uploading Data from the G9SP-series Controller
The final configuration data can be read from the G9SP-series Controller.
■
Resetting
The G9SP-series Controller can be restarted or the configuration data can be
deleted and the G9SP-series Controller returned to the default status.
■
Setting a Device Password
A Device Password can be set to prevent unapproved access to the G9SP-
series Controller, including changes to the configuration data and changing
the modes.
G9SP Configurator
Upload
Download
Section 8-1
G9SP-series Controller