Setting a Device Password
8-5
Setting a Device Password
Scope of Access Control
Lost Device Password
Procedure for Setting Device Password
1,2,3...
Blank when no
password is set.
The G9SP-series Controller can record a Device Password in nonvolatile
memory. The Device Password can be used to prevent unauthorized or unin-
tentional access to the G9SP-series Controller from a person other than a
user (i.e., a safety manager).
No Device Password is set by default; the user must register one. Use the
G9SP Configurator to set or change the Device Password for the G9SP-series
Controller.
The following operations require the user to enter a Device Password. The
G9SP-series Controller will not perform the following operations unless the
password is correct.
• Downloading the configuration
• Locking or unlocking the configuration
• Executing the Controller's reset service
• Changing the operating mode
• Changing the password
Contact your OMRON representative if you lose the password that is set in the
G9SP-series Controller. For details, refer to Appendix B Using the Password
Recovery Tool.
1. Go online and select Change Device Password from the Communication
Menu.
2. In the Change Password Window shown below, input the current password
and the new password.
Additional Information
For details on the Device Password, refer to 6-3 Designing Device Security.
Section 8-5
Input 6 to 16 characters.
Input the same password again.
137