Garmin G1000 Reference Manual page 206

SECTION 13 – ANNUNCIATIONS
& ALERTS
GIA 63W Message Advisories (Cont.)
Message
GIA1 CONFIG – GIA1 audio config
error. Config service req'd.
GIA2 CONFIG – GIA2 audio config
error. Config service req'd.
GIA1 COOLING – GIA1 temperature
too low.
GIA2 COOLING – GIA2 temperature
too low.
GIA1 COOLING – GIA1 over
temperature.
GIA2 COOLING – GIA2 over
temperature.
GIA1 SeRVICe – GIA1 needs service.
Return the unit for repair.
GIA2 SeRVICe – GIA2 needs service.
Return the unit for repair.
HW MISMATCH – GIA hardware
mismatch. GIA1 communication
halted.
HW MISMATCH – GIA hardware
mismatch. GIA2 communication
halted.
MANIFeST – GIA1 software
mismatch, communication halted.
MANIFeST – GIA2 software
mismatch, communication halted.
MANIFeST – GFC software mismatch,
communication halted.
COM1 TeMP – COM1 over temp.
Reducing transmitter power.
COM2 TeMP – COM2 over temp.
Reducing transmitter power.
13-16
Comments
The GIA1 and/or GIA2 have an error in the audio configuration. The G1000
system should be serviced.
The GIA1 and/or GIA2 temperature is too low to operate correctly. Allow units to
warm up to operating temperature.
The GIA1 and/or GIA2 temperature is too high. If problem persists, the G1000
system should be serviced.
The GIA1 and/or GIA2 self-test has detected a problem in the unit. The G1000
system should be serviced.
A GIA mismatch has been detected, where only one is WAAS capable.
The GIA1 and/or GIA 2 has incorrect software installed. The G1000 system
should be serviced.
Incorrect servo software is installed, or gain settings are incorrect.
The system has detected an over temperature condition in COM1 and/or COM2.
The transmitter is operating at reduced power. If the problem persists, the G1000
system should be serviced.
Garmin G1000 Cockpit Reference Guide for the Cessna Nav III 190-00384-09 Rev. A