Load And/Or Activate An Approach Procedure - Garmin G1000 Reference Manual

load and/or Activate an Approach Procedure

1) Press the PROC Key.
2) Turn the large FMS Knob to highlight 'SELECT
APPROACH'.
3) Press the eNT Key.
4) If a flight plan is active, the destination airport
is displayed as the default. A list of available
approaches is also displayed. If no flight plan is
active, use the FMS Knobs to enter the identifier of
the desired airport. Press the eNT Key.
5) Turn the large FMS Knob to highlight the Approach
field. Turn the small FMS Knob to display a list of
available approaches.
Figure 9-6 Selecting an Approach Procedure
6) Turn either FMS Knob to highlight the desired
approach. Press the eNT Key.
7) The cursor moves to the TRANSITIONS field. Turn
the large FMS Knob to highlight the desired
transition waypoint and press the eNT Key. (The
"Vectors" option assumes vectors will be received
to the final course segment of the approach and
will provide navigation guidance relative to the final
approach course.)
190-00384-09 Rev. A Garmin G1000 Cockpit Reference Guide for the Cessna Nav III
SECTION 9 – PROCEDURES
Figure 9-7 Selecting an Approach Transition
8) The cursor moves to the MINIMUMS field. If
desired, the decision altitude for the selected
approach procedure may be entered and displayed
on the PFD as described in the Barometric Altitude
Minimums discussion in the Flight Instruments
section. Turn the small FMS Knob in the direction
of the green arrow to change the display from OFF
to BARO. Press the eNT Key.
Figure 9-8 Selecting Barometric Altitude
Minimums
9-3