Garmin G1000 Reference Manual page 137

For point-to-point planning, turn the FMS Knobs to
enter the identifier of the starting waypoint. Once
the waypoints identifier is entered, press the eNT
Key to accept the waypoint. The flashing cursor
moves to the ending waypoint. Again, turn the FMS
Knobs to enter the identifier of the ending waypoint
and press the eNT Key to accept the waypoint.
Or:
For flight plan leg planning, press the FPL Softkey (at
the bottom of the display) and turn the small FMS
Knob to select the desired flight plan (already stored
in memory), by number. Turn the large FMS Knob
to highlight the 'LEG' field and turn the small FMS
Knob to select the desired leg of the flight plan, or
select 'CUM' to apply trip planning calculations to
the entire flight plan. Selecting 'FPL 00' displays the
active flight plan. If the active flight plan is selected,
'REM' is an available option to display planning
data for the remainder of the flight plan.
NOTe: The Page Mode must be set to MANUAL
to perform the following steps.
5) Turn the large FMS Knob to highlight the departure
time (DEP TIME) field.
NOTe: The departure time on the Trip Planning
Page is used for preflight planning. Refer to the
Utility Page for the actual flight departure time.
6) Turn the FMS Knobs to enter the departure time.
Press the eNT Key when finished. (Departure time
may be entered in local or UTC time, depending
upon system settings).
190-00384-09 Rev. A Garmin G1000 Cockpit Reference Guide for the Cessna Nav III
SECTION 8 – FLIGHT PLANNING
7) Turn the FMS Knobs to enter the fuel flow. Press
the eNT Key when finished. Note that in automatic
page mode, fuel flow is provided by the system.
8) The flashing cursor moves to the fuel on board field.
Turn the FMS Knobs to modify the fuel on board.
Press the eNT Key when finished. In 'AUTOMATIC'
mode, fuel onboard is provided by the entry made
in 'GAL REM' on the EIS System Page.
9) The flashing cursor moves to the calibrated airspeed
field. Turn the FMS Knobs to enter a calibrated
airspeed. Press the eNT Key when finished.
10) The flashing cursor moves to the indicated altitude
field. Turn the FMS Knobs to enter indicated
altitude. Press the eNT Key when finished.
11) The flashing cursor moves to the barometric
pressure field. Turn the FMS Knobs to enter the
altimeter barometric pressure setting. Press the
eNT Key when finished.
12) The flashing cursor moves to the total air
temperature field. Turn the FMS Knobs to enter
the total air temperature. Press the eNT Key when
finished.
8-9