Toshiba e-STUDIO2006 Service Manual page 668

05/08 Mode Element Sub element
08 Setting Mode System
08 Setting Mode System
08 Setting Mode System
08 Setting Printer Paper
mode feeding
08 Setting Printer Laser
mode
08 Setting Printer Laser
mode
08 Setting Printer Laser
mode
08 Setting Printer Paper Automatic change of
mode feeding paper source
e-STUDIO2303A/2303AM/2803AM/2309A/2809A
SELF-DIAGNOSIS CODE (03/04/05/08 CODE)
Sub-
Item Subitem Code
code
3992 - Status setting after the
period set for
recovering from the
Sleep mode has
passed
3993 - Transmission setting of
a fax job notification
mail
3994 - Switch the CSV / XML
of the Notification
4010 - Default setting of paper
source
4012 - Pre-running rotation of
polygonal motor
4013 - Polygonal motor
rotational status
switching at the Auto
Clear Mode
4015 - Polygonal motor stop
period
When a 4016 0 PPC
drawer is
specified
Default Acceptable
Details SRAM
value value
0 0-1 SYS
0 0-1 SYS
1 0-1 SYS
0 0-4 SYS
0 0-2 SYS
0 0-1 SYS
3 0-6 SYS
0 0-1 SYS
14-2-52
Contents
Sets the status (Sleep mode or recover from the Sleep
mode) into which the equipment enters after the period set
in 08-3974 (time setting for recovering from the Sleep
mode) has passed.
0: Sleep
1: Startup (recovering from the Sleep mode)
Sets whether or not to send a notification mail when fax
reception forwarding fails.
0: Disabled
1: Enabled
When "1" (Enabled) is selected, a notification mail will be
sent if fax reception forwarding has failed.
0：XML
1：CSV
0: A4/LT
1: Drawer 1 (Upper)
2: Drawer 2 (Lower)
3: PFP Drawer 1 (Upper)
4: PFP Drawer 2 (Lower)
* In 23LA, 08-4010 is enabled only when the RADF is used.
The upper drawer is selected when it is not.
Sets whether or not switching the polygonal motor from the
standby rotation to the normal rotation when the original is
set on the RADF or the original cover is opened.
0: Enabled (RADF / Original cover)
1: Disabled
2: Enabled (RADF only)
Sets whether or not switching the polygonal motor from the
normal rotation to the standby rotation at the Auto Clear
Mode.
0: Valid
1: Invalid
Switches the polygonal motor to the standby rotation when
a certain period of time has passed from the prerunning.
At this code, the period to switch the status to the standby
rotation is set.
0: 15sec, 1: 20sec, 2: 25sec, 3: 30sec, 4: 35sec, 5:
40sec, 6: 45sec
Sets whether the automatic change of paper source is
performed or not if the drawer or bypass tray is specified as
the paper source and the paper in it runs out when coping.
0: Does not change the paper source automatically
1: Changes the paper source automatically
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
Proce 23LM/ 23HA/
23LA
dure 28LM 28HA
1 - Y Y
1 Y Y Y
1 - - Y
1 Y Y Y
1 Y Y Y
1 Y Y Y
1 Y Y Y
4 - - Y