Registration Roller (Metal) - Toshiba e-STUDIO2006 Service Manual

4.6.14

Registration roller (metal)

(1) Open the right cover.
(2) Take off the process unit.
 P. 4-49 "4.7.1 Process unit <20L/23L/25L/
20H/23H/25H>"
 P. 4-50 "4.7.2 Process unit <23LA/23LM/
28LM/23HA/28HA>"
(3) Take off the registration roller clutch.
 P. 4-43 "4.6.13 Registration roller clutch
(CLT1)"
(4) Remove 1 clip [1].
(5) Slide the registration roller (metal) [2] to the
rear side, and take it off.
Notes:
Each 1 bushing is attached on both front and
rear side of the registration roller (metal),
take care not to drop the bushings while
removing the registration roller (metal).
(6) Remove 1 E-ring [3] and 1 gear [4].
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
DISASSEMBLY AND REPLACEMENT
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
4 - 44
[1]
Fig. 4-112
[2]
Fig. 4-113
[3]
[4]
Fig. 4-114