Toshiba e-STUDIO2006 Service Manual page 304

[B] Primary scanning data laser writing start position / Drawer sideways deviation
Notes:
Make sure the first line of the grid pattern is printed out since the line is occasionally vanished.
[B-1] Primary scanning data laser writing start position
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.  (Adjustment Mode)
(2) [SETTINGS]  [USER FUNCTIONS]  Select [DRAWER]  Select [DRAWER1]
 Set the paper size to A3/LD.  [OK]  Set A3/LD for the paper in upper drawer.
(3) [CANCEL]  [CANCEL]  [SETTINGS] (Return to code entry screen)
 [1]  [SETTINGS]  [START] (A grid pattern with 10 mm squares is printed out.)
(4) Check the grid pattern on the test chart printed out and measure the distance B from the left edge
of the paper to the 6th line of the grid pattern.
(5) Check if the distance B is within 52±0.5 mm.
(6) If not, use the following procedure to change values and measure the distance B again.
(Adjustment Mode)  (Key in the code [4006])  [START]
 (Key in a value (acceptable values: 0 to 255))
 [OK] (Stored in memory)
 Press [1]  Press [SETTINGS]  [START]  (A grid pattern is printed out.)
* The larger the adjustment value is, the longer the distance B becomes (approx. 0.04 mm/
step).
(7) After the adjustment for the code 4006 is completed, apply the same adjustment value for the
code 4005.
(Adjustment Mode)  (Key in the code [4005])  [START]
 (Key in the same value in the step 6 above)
 Press [OK] (Stored in memory).
[B-2] Drawer sideways deviation
This adjustment has to be performed for each paper source. (If there is no paper source, skip this step.)
The following table shows the order of the paper source to be adjusted, code, paper size and
acceptable values.
Order for
Paper source
adjustment
1 Lower drawer (PFU)
2 PFP1 (Upper drawer)
3 PFP2 (Lower drawer)
4 Bypass feed
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.  (Adjustment Mode)
(2) [SETTINGS]  [USER FUNCTIONS]  Select [DRAWER]  Select the paper source  Set
the paper size to A3/LD.  [OK]  Set A3/LD for the paper in the drawer.
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
SETTING / ADJUSTMENT
Code Paper size
4018-1 A3/LD
4018-2 A3/LD
4018-3 A3/LD
4018-5 A3/LD
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
6 - 10
Acceptable
Remarks
value
0 to 255
0 to 255 <20H/23H/25H, 23HA/28HA>
0 to 255 <20H/23H/25H, 23HA/28HA>
0 to 255