Skew (Inclined Image) - Toshiba e-STUDIO2006 Service Manual

8.4.11

Skew (inclined image)

Defective area
Drawers
Feed roller
Rollers
Registration roller
Pre-registration guide
CIS unit
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
ERROR CODE AND TROUBLESHOOTING
Fig.8-13
Step Check items
1 Is the drawer properly installed?
2 Is there too much paper in the
drawer?
3 Is the corner of the paper folded?
4 Are the side guides of the drawer
properly installed?
5 Is the surface of the feed roller dirty?
6 Are the roller and shaft secured?
7 Is the spring detached from the
registration roller?
8 Is the pre-registration guide properly
installed?
9 Is the CIS unit slanted?
8 - 78
Prescription
Install the drawer properly.
Reduce paper to 250 or fewer sheets
in the drawer.
Change the direction of the paper
and set it again.
Adjust the position of the side guides.
Clean the feed roller surface with
alcohol, or replace the roller.
Check and tighten the E-rings, pins,
clips and setscrews.
Attach the spring correctly. Clean the
roller if it is dirty.
Correct it.
Replace the CIS case.
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved