Other Jam - Toshiba e-STUDIO2006 Service Manual

8.3.6

Other jam

[E030] Paper remaining inside the equipment at power-ON
Classification
Other jam
Proce
Check item
dure
Open the cover of the unit/
1
area whose picture is
blinking on the control
panel. Is there any paper
on the transport path?
(Refer to the following
table.)
2 Is the sensor in the
jamming area working?
(Perform the input check
in the test mode: refer to
the following table.)
MAIN board
3
Parts to be replaced
Sensor
MAIN board
Relation between the jamming area and the corresponding sensors and covers
(If a jam is occurring in the PFU check the board in each unit.)
Jamming area
Registration area Right cover
Exit area Right cover
ADU Right cover
PFU PFU side cover
PFP PFP side cover
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
ERROR CODE AND TROUBLESHOOTING
Power-ON jam
Result
Yes Remove the paper.
No
Yes
No • Check if the connector of the sensor is
disconnected.
• Check if any of the connectors on the MAIN
board is disconnected.
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Check if the conductor pattern on the MAIN
board is short circuited or open circuited.
• Replace the sensor
• Replace the MAIN board.
Refer to the following table
Cover
Registration sensor
Exit sensor
ADU paper path sensor
PFU drawer feed sensor
PFP upper drawer feed sensor
PFP upper lower feed sensor
8 - 38
Error content
Measure
Remark
Sensor Test mode / Input check
03-[A]/[A]
03-[A]/[B]
03-[1]/[C]
03-[4]/[A]
03-[1]/[E]
03-[2]/[C]
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
Next
Step
2
3