Toshiba e-STUDIO2006 Service Manual page 362

<23LA/23LM/28LM/23HA/28HA>
Items to check
H1 Photoconductive drum
H2 Discharge LED
H3 Whole cleaner unit
H4 Drum cleaning blade
H5 Drum separation finger
H6 Recovery blade
H7 Ozone filter
H8 Drum Shaft
* h1. Drum cleaning blade
Since the edge of the blade is vulnerable and can be easily damaged by factors such as
the adherence of paper dust. Replace the cleaning blade with new ones if poor images are
printed due to the damaged blade regardless of the number of output pages if which have
been made.
* h2. Separation fingers for drum
The paper jam may be caused if the tip of the separation finger is damaged or deformed. If
there is any problem with it, replace the finger with a new one regardless of the number of
output pages which have been made.
If any mark which was made by the finger appears on the printed image, clean the tip of
the finger.
* h3. Recovery blade
Replace the recovery blade regardless the number of output pages if the edge of the blade
get damaged.
Notes:
1. Wipe the tip of the finger lightly with a dry cloth trying not to deform it.
Do not leave the lint on the tip.
2. Apply patting powder to the tip of the fingers and drum surface after replacing or cleaning
them to reduce the load on the drum surface by the finger.
Remarks:
Values under "Replacement" indicate the replacement cycle for the 23LA/23LM/28LM, 23HA /
28HA.
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
PREVENTIVE MAINTENANCE (PM)
Cleaning Lubrication
B
B
B
FL
7 - 20
Replacement
Operation
x1,000
x1,000
check
drive
sheets
count
59/64 115
59/64 115
177/ 345
192
177/ 345
192
177/ 345
192
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
Parts list
Remarks
<P-I>
15-20 Ch.7.8.2
13-2
15-1
15-5 *h1
15-17 *h2
15-6 *h3
9-3
15-21