Bank Angle Sensor - APRILIA DORSODURO FACTORY ABS 2011 Service Station Manual

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
DORSODURO FACTORY ABS
Side stand
Example value:up/down
Indication on Navigator always down: check the connector: if not OK, restore; if it is OK, disconnect
the two terminals from the sensor and check continuity to ground of PIN 1: if there is no continuity,
restore the cable harness; if there is, replace the sensor.
Indication on Navigator always up: disconnect the terminals from the sensor and check if there is
continuity between the two PINS, with stand down: if there is continuity, replace the sensor; if the circuit
is open, it means that the brown/green cable from sensor PIN 2 to ENGINE connector PIN 6 is short
circuit to ground: restore the cable harness.

Bank angle sensor

FALL SENSOR
Function
it tells the vehicle position to the control unit.
Operation / Operating principle
When the sensor is inverted, the circuit is closed
to ground: When the Marelli control unit detects
this ground connection, it does not enable start-up
or shuts off the engine.
Level in electrical circuit diagram:Start-up ena-
bling switches.
Location:
•
on the vehicle: under the saddle
•
connector: near the sensor
Electrical characteristics:
•
Sensor in vertical position: open circuit
(resistance: 62 kOhm)
•
Sensor inverted: closed circuit (con-
tinuity)
Pin-out:
1. Ground connection
2. Voltage 5V
CAUTION
BEFORE CARRYING OUT ANY TROUBLESHOOTING, CAREFULLY READ THE GENERAL TROU-
BLESHOOTING CONCEPTS FOR ELECTRICAL DEVICES AT THE BEGINNING OF THE CHECK
AND CONTROL SECTION IN THE ELECTRICAL SYSTEM CHAPTER.
NAVIGATOR: PARAMETERS
Fall sensor
email: info@motomatrix.co.uk
Electrical system
ELE SYS - 159