APRILIA DORSODURO FACTORY ABS 2011 Service Station Manual page 121

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
DORSODURO FACTORY ABS
5DA2 the signal decreases periodically: Possible tone wheel fault due to deformations or dirt; pos-
sible alterations on the wheel bearing surface. In very rare cases, abnormal tone wheel vibrations.
Troubleshooting: Check if the tone wheel is dirty, deformed or wrongly fixed. If the tone wheel is not
OK, replace it. If it is OK, check for possible faults in the wheel bearings and if it is not OK, replace the
bearings.
5DA3 no signal or speed measured too low in relation to the front wheel: Faulty sensor or missing
sensor/tone wheel. Or excessive distance between the sensor and the tone wheel or tone wheel with
wrong number of teeth.
Troubleshooting: Check that the speed sensor and the tone wheel are installed. If they are not, install
them. If they are, check the speed sensor retainer. If it is not OK, restore it. If it is, check if the tone
wheel has the correct number of teeth or if it is dirty, deformed or wrongly fixed. If it is not OK, replace
the tone wheel and if it is OK, replace the speed sensor.
5DA4 missing acceleration after pressure reduction: Faulty sensor or missing sensor/tone wheel
or excessive distance between the sensor and the tone wheel.
Troubleshooting: Check that the speed sensor and the tone wheel are installed. If they are not, install
them. If they are, check the speed sensor retainer. If it is not OK, restore it. If it is, check if the tone
wheel has the correct number of teeth or if it is dirty, deformed or wrongly fixed. If it is not OK, replace
the tone wheel and if it is OK, replace the speed sensor.
5DA5 excessive measured speed: Faulty sensor or tone wheel, or tone wheel with wrong number of
teeth or wrong tyre size.
Troubleshooting:Check that the speed sensor and the tone wheel are installed. If they are not, install
them. If they are, check the speed sensor retainer. If it is not OK, restore it. If it is, check if the tone
wheel has the correct number of teeth or if it is dirty, deformed or wrongly fixed. If it is not OK, replace
the tone wheel and if it is OK, check that the tyre size is the correct one. If it is not OK, replace it. If it is
OK, check that the tyre pressure is the correct one. If it is not OK, restore it; if it is OK, replace the speed
sensor.
Engine rpm sensor
ENGINE SPEED SENSOR
Function
It informs crankshaft position and speed to the
Marelli control unit.
Operation / Operating principle
Inductive sensor: sinusoidal-type generated volt-
age; two teeth are missing on the flywheel for the
reference position.
email: info@motomatrix.co.uk
Electrical system
ELE SYS - 121