Table of Contents
Advertisement
Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
DORSODURO FACTORY ABS
•
Tighten the intermediate gear pin once
Loctite residues are thoroughly re-
moved and a high-strength threadlock
is applied on the thread.
•
Make sure that both timing chain slid-
ers are correctly fitted.
•
Refit the overhead camshafts following
the procedure described in the "Tim-
ing" section.
See also
Selecting the base gasket
Selecting the base gasket
•
Place the specific special tool on the
piston, which should have sealing rings
and be fitted on the connecting rod.
•
Lock the special tool with the clamp.
Specific tooling
AP8140302 tool for sealing ring fitting
•
Temporarily, fit the piston to the cylin-
der, without base or head gasket.
•
Remove the clamp from the sealing
ring locking tool.
•
Remove the special tool for locking the
connecting rod.
•
Fit a dial gauge on the specific tool.
•
Set the dial gauge to zero on a refer-
ence surface with a medium preload,
e.g. 5 mm (0.2 in). Keeping the zero
setting, fit the tool on the cylinder and
lock it with two nuts (10 Nm - 7.38 lb ft)
as shown in the figure.
Specific tooling
email: info@motomatrix.co.uk
Engine
ENG - 231
Hide quick links:
Advertisement
Table of Contents
