APRILIA DORSODURO FACTORY ABS 2011 Service Station Manual page 156

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
Electrical system
Neutral sensor
GEAR IN NEUTRAL SENSOR
Function
it tells the gear position to the control unit: if it is in
neutral or in gear.
Operation / Operating principle
for gear in neutral, the circuit is closed to ground
connection: then, via CAN, the control unit sends
the signal to the instrument panel which turns on
the neutral speed warning light.
Level in electrical circuit diagram:Start-up ena-
bling switches
Location:
•
on the vehicle: left side of the vehicle,
near flywheel cover
•
connector: upper part of the flywheel
cover
Electrical characteristics:
•
gear in neutral: closed circuit (continu-
ity)
•
gear engaged: open circuit (infinite re-
sistance)
Pin-out:
1. Voltage 12V
CAUTION
BEFORE CARRYING OUT ANY TROUBLESHOOTING, CAREFULLY READ THE GENERAL TROU-
BLESHOOTING CONCEPTS FOR ELECTRICAL DEVICES AT THE BEGINNING OF THE CHECK
AND CONTROL SECTION IN THE ELECTRICAL SYSTEM CHAPTER.
NAVIGATOR: STATUSES
Gear in neutral
Example value:yes/no
NAVIGATOR: NOTES
•
Indication on the instrument panel always gear engaged: check the correct position of the
cable terminals on the connector and the correct connection of the cables on the terminals.
If they are not correct, restore the cable harness; if correct, disconnect the connector and,
with gear in neutral, check continuity to terminal ground connection, sensor side: if there is
no continuity, replace the sensor (after checking cable continuity on the sensor side and the
correct mechanical position). If there is, check the correct position of the terminal on the
ELE SYS - 156
email: info@motomatrix.co.uk
DORSODURO FACTORY ABS