Authorization (Line) - Cisco NCS 5000 Series Manual

Authentication, Authorization, and Accounting Commands

authorization (line)

To enable authentication, authorization, and accounting (AAA) authorization for a specific line or group of
lines, use the authorization command in line template configuration mode. To disable authorization, use the
no form of this command.
authorization {commands| exec | eventmanager} {default| list-name}
no authorization {commands| exec | eventmanager}
Syntax Description
commands
exec
default
eventmanager
list-name
Command Default
Authorization is not enabled.
Command Modes
Line template configuration
Command History
Release
Release 6.0
Usage Guidelines
After you use the aaa authorization command to define a named authorization method list (or use the default
method list) for a particular type of authorization, you must apply the defined lists to the appropriate lines for
authorization to take place. Use the authorization command to apply the specified method lists (or, if none
is specified, the default method list) to the selected line or group of lines.
Task ID
Task ID
aaa
Enables authorization on the selected lines for all commands.
Enables authorization for an interactive XR EXEC mode session.
Applies the default method list, created with the aaa authorization command.
Sets eventmanager authorization method. This method is used for the embedded
event manager.
Specifies the name of a list of authorization methods to use. If no list name is
specified, the system uses the default. The list is created with the aaa
authorization command.
Operations
read, write
System Security Command Reference for Cisco NCS 5000 Series Routers
authorization (line)
Modification
This command was introduced.
25