Taskgroup - Cisco NCS 5000 Series Manual

taskgroup

taskgroup
To configure a task group to be associated with a set of task IDs, and to enter task group configuration mode,
use the taskgroup command in XR Config mode. To delete a task group, use the no form of this command.
taskgroup taskgroup-name [description string| task {read| write| execute| debug} taskid-name| inherit
taskgroup taskgroup-name]
no taskgroup taskgroup-name
Syntax Description
taskgroup-name
description
string
task
read
write
execute
debug
taskid-name
inherit taskgroup
taskgroup-name
Command Default
Five predefined user groups are available by default.
Command Modes
XR Config mode
Command History
Release
Release 6.0
System Security Command Reference for Cisco NCS 5000 Series Routers
102
Authentication, Authorization, and Accounting Commands
Name of a particular task group.
(Optional) Enables you to create a description for the named task group.
(Optional) Character string used for the task group description.
(Optional) Specifies that a task ID is to be associated with the named task
group.
(Optional) Specifies that the named task ID permits read access only.
(Optional) Specifies that the named task ID permits read and write access
only.
(Optional) Specifies that the named task ID permits execute access.
(Optional) Specifies that the named task ID permits debug access only.
(Optional) Name of a task: the task ID.
(Optional) Copies permissions from the named task group.
(Optional) Name of the task group from which permissions are to be
inherited.
Modification
This command was introduced.