Timeout Login Response - Cisco NCS 5000 Series Manual

Authentication, Authorization, and Accounting Commands

timeout login response

To set the interval that the server waits for a reply to a login, use the timeout login response command in
line template configuration mode. To restore the default, use the no form of this command.
timeout login response seconds
no timeout login response seconds
Syntax Description
seconds
Command Default
seconds: 30
Command Modes
Line template configuration
Command History
Release
Release 6.0
Usage Guidelines
Use the timeout login response command in line template configuration mode to set the timeout value. This
timeout value applies to all terminal lines to which the entered line template is applied. This timeout value
can also be applied to line console. After the timeout value has expired, the user is prompted again. The retry
is allowed three times.
Task ID
Task ID
aaa
Examples The following example shows how to change the interval timer to 20 seconds:
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# line template alpha
RP/0/RP0/CPU0:router(config-line)# timeout login response 20
Integer that specifies the timeout interval (in seconds) from 0 to 300.
Operations
read, write
System Security Command Reference for Cisco NCS 5000 Series Routers
timeout login response
Modification
This command was introduced.
105