Inband - Cisco NCS 5000 Series Manual

inband

inband
To configure an inband interface and to enter management plane protection inband configuration mode, use
the inband command in management plane protection configuration mode. To disable all configurations
under inband configuration mode, use the no form of this command.
inband
no inband
Syntax Description
This command has no keywords or arguments.
Command Default
None
Command Modes
Management plane protection inband configuration
Command History
Release
Release 6.0.1
Usage Guidelines
Use the inband command to enter management plane protection inband configuration mode.
Task ID
Task ID
system
Examples The following example shows how to enter management plane protection inband configuration mode using
the inband command:
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# control-plane
RP/0/RP0/CPU0:router(config-ctrl)# management-plane
RP/0/RP0/CPU0:router(config-mpp)# inband
RP/0/RP0/CPU0:router(config-mpp-inband)#
System Security Command Reference for Cisco NCS 5000 Series Routers
136
Management Plane Protection Commands
Modification
This command was introduced.
Operations
read, write