Cisco NCS 5000 Series Manual page 139

Management Plane Protection Commands
address ipv4 (MPP)
Examples
The following example shows how to configure the peer IPv4 address 10.1.0.0, with a prefix of 16 for traffic
management:
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# control-plane
RP/0/RP0/CPU0:router(config-ctrl)# management-plane
RP/0/RP0/CPU0:router(config-mpp)# inband
RP/0/RP0/CPU0:router(config-mpp-inband)# interface all
RP/0/RP0/CPU0:router(config-mpp-inbandoutband-all)# allow all peer
RP/0/RP0/CPU0:router(config-telnettftp-peer)# address ipv4 10.1.0.0/16
System Security Command Reference for Cisco NCS 5000 Series Routers
131