Address Ipv4 (Mpp) - Cisco NCS 5000 Series Manual

address ipv4 (MPP)

address ipv4 (MPP)
To configure the peer IPv4 or IPv6 address in which management traffic is allowed on the interface, use the
address ipv4command in interface peer configuration mode. To remove the IP address that was previously
configured on this interface, use the no form of this command.
address {ipv4| ipv6} peer-ip-address |peer-ip-address/length
no address {ipv4| ipv6} peer-ip-address| peer-ip-address/length
address ipv4 {peer-ip-address| peer-ip-address/ length}
no address ipv4 {peer-ip-address| peer-ip-address/ length}
Syntax Description
peer-ip-address
peer ip-address/length
Command Default
If no specific peer is configured, all peers are allowed.
Command Modes
Interface peer configuration
Command History
Release
Release 6.0.1
Usage Guidelines
No specific guidelines impact the use of this command.
Task ID
Task ID
system
System Security Command Reference for Cisco NCS 5000 Series Routers
130
(Required) Peer IPv4 or IPv6 address in which management traffic is allowed
on the interface. This address can effectively be the source address of the
management traffic that is coming in on the configured interface.
(Required) Prefix of the peer IP address and IPv4 address. or IPv6 format:
• IPv4—A.B.C.D/length
• IPv6—X.X:X.X
Operations
read, write
Management Plane Protection Commands
Modification
This command was introduced.