Mercedes-Benz S 350 Owner's Manual page 537

P40.10-4524-31
1 Wheel wrench
Take wheel wrench 1 out of the vehi-
cle tool kit.
Loosen the wheel bolts on the wheel to
be changed by about one turn, but do
not unscrew them.
G
Risk of accident
Position the jack only at one of the appropri-
ate jacking points.
If you do not position the jack correctly, the
vehicle can:
slip off the jack
injure you or others
be damaged
P40.10-4527-31
1 Jacking point
2 Jack
3 Crank
Position jack 2 at jacking point 1.
P40.10-4100-31
Make sure that the base of the jack is
located directly under jacking point 1.
Practical advice
Turn crank 3 until the tyre is raised a
maximum of 3 cm from the ground.
P40.10.4528-31
1 Centring pin
Undo the uppermost wheel bolt com-
pletely.
In place of the wheel bolt, screw cen-
tring pin 1 from the vehicle tool kit
into the thread.
Undo the remaining wheel bolts.
!
Do not place wheel bolts in sand or on a dirty
surface. This could cause damage to the bolt and
wheel hub threads.
Remove the wheel.
Flat tyre
515