Back Button - Mercedes-Benz S 350 Owner's Manual

Operating systems
COMAND navigation system* (entering a destination)
To change manually to the destina-
tion memory list without input char-
acters: slide qm.
or
Select ? in the second to bottom line
and press n.
Destination memory list without input
characters
P83.86-5333-31
To select a destination: slide
turn ymz.
To cancel the selection: press the
L back button.
or
Select "Back" and press n.
i
The "Back" menu item is only available if this
list was called up from the list with input charac-
ters.
160
To confirm the selection: press n.
To start route calculation: select "Start",
see also ( page 158).
Entering the destination from the
list of previous destinations
Select "Navi"
"From last destinations".
The list of previous destinations ap-
pears. The most recent destination is
at the top of the list.
Select the desired destination.
To start route calculation: select
"Start", see also ( page 158).
Entering a destination using the map
i
In certain countries, it is not possible to en-
ter a destination using the map if the vehicle is
travelling at more than approximately 5 km/h.
or
As soon as the vehicle speed drops below about
qmr
3 km/h, the function is available again.
You can enter a destination using the map if the
digital map does not contain the address of the
destination, but it is within the area of the digital
map.
Calling up the map
Select "Map" in the address input
menu ( page 147).
or
"Destination"
1 Crosshair
2 Details of the crosshair position
3 Map scale selected
i
example, provided the digital map contains the
necessary data.
If no data is available, display 2 shows:
Select "Navi" "Destination"
"Using map".
In both this cases, you will see the map
with a crosshair.
P68.20-5053-31
Display 2 may be the name of a road, for
the coordinates if the geo-coordinate display
is switched on ( page 144) and the GPS
signal is strong enough
no display if the geo-coordinate display is
switched off ( page 144)