Mercedes-Benz S 350 Owner's Manual page 164

Operating systems
COMAND navigation system* (introduction)
To show: press n in the full-screen
map display.
Adjusting the map scale
i
It is only possible to adjust the map scale
with the menu system hidden (full-screen map
display).
Turn until you have set the de-
ymz
sired map scale.
Scale bar 4 appears as soon as you
turn ymz. Turning clockwise enlarges
the map, turning anti-clockwise reduc-
es the map scale.
142
P68.20-5112-31
1 Currently set map scale as a number,
here 100 m (1 cm on the map repre-
sents 100 m on the ground)
2 Currently set map scale as indicated by
the needle on the scale bar
3 Previously set scale before calling up
current scale
4 Scale bar
Storing the current vehicle position as
a destination in the list of previous des-
tinations
If necessary, show the menu sys-
tem: press n.
To store: select "Position"
position".
COMAND stores the current vehicle
position as a destination in the list of
previous destinations ( page 189).
Moving the map
i
It is only possible to move the map with the
menu system hidden.
In certain countries, it is not possible to move
the map freely if the vehicle is travelling at more
than approximately 5 km/h. As soon as the ve-
hicle speed drops below about 3 km/h, it is pos-
sible to move the map freely again.
Slide qmr,
omp
A crosshair appears on the map.
P68.20-5053-31
"Save
1 Crosshair
2 Details of the crosshair position
3 Map scale selected
or wmx.