Mld Snooping Proxying Configuration Example - HP A8800 Configuration Manual

Sent
Received error MLD messages:0.

MLD snooping proxying configuration example

Network requirements
As shown in
MLD querier.
Configure MLD snooping proxying on Router B, enabling the switch to forward MLD reports and done
messages on behalf of attached hosts and to respond to MLD queries from Router A and forward the
queries to the hosts on behalf of Router A.
Figure 84 Network diagram
Configuration procedure
1. Assign an IP address and prefix length to each interface as per
2. On Router A, enable IPv6 multicast routing, enable MLD on port GigabitEthernet 3/1/1, and
enable IPv6 PIM-DM on each interface.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface GigabitEthernet 3/1/1
[RouterA-GigabitEthernet3/1/1] mld enable
[RouterA-GigabitEthernet3/1/1] pim ipv6 dm
[RouterA-GigabitEthernet3/1/1] quit
[RouterA] interface GigabitEthernet 3/1/2
[RouterA-GigabitEthernet3/1/2] pim ipv6 dm
[RouterA-GigabitEthernet3/1/2] quit
3. Configure Router B:
# Enable MLD snooping globally.
<RouterB> system-view
[RouterB] mld-snooping
[RouterB-mld-snooping] quit
MLDv2 specific sg queries:0.
Figure 84, Router A runs MLDv1 and Router B runs MLDv1 snooping. Router A acts as an
314
Figure 84. (Details not shown.)