HP A8800 Configuration Manual page 49

Figure 15 Network diagram
Source
1.1.1.1/24
Configuration procedure
1. Assign an IP address and subnet mask to each interface as per
2. On Router A, enable IP multicast routing globally, enable IGMP on GigabitEthernet 2/1/1, and
enable PIM-DM on each interface.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface GigabitEthernet 2/1/1
[RouterA-GigabitEthernet2/1/1] igmp enable
[RouterA-GigabitEthernet2/1/1] pim dm
[RouterA-GigabitEthernet2/1/1] quit
[RouterA] interface GigabitEthernet 2/1/2
[RouterA-GigabitEthernet2/1/2] pim dm
[RouterA-GigabitEthernet2/1/2] quit
3. Configure Device A:
# Enable IGMP snooping globally.
<DeviceA> system-view
[DeviceA] igmp-snooping
[DeviceA-igmp-snooping] quit
# Switch the link mode of GigabitEthernet 2/1/1 through GigabitEthernet 2/1/3 to Layer 2 mode,
create VLAN 100, assign GigabitEthernet 2/1/1 through GigabitEthernet 2/1/3 to this VLAN,
and enable IGMP snooping in the VLAN.
[DeviceA] interface GigabitEthernet 2/1/1
[DeviceA-GigabitEthernet2/1/1] port link-mode bridge
[DeviceA-GigabitEthernet2/1/1] quit
[DeviceA] interface GigabitEthernet 2/1/2
[DeviceA-GigabitEthernet2/1/2] port link-mode bridge
[DeviceA-GigabitEthernet2/1/2] quit
GE2/1/2 GE2/1/1
1.1.1.2/24 10.1.1.1/24
Router A
IGMP querier
Device A
GE2/1/1
Host C
Receiver
VLAN 100
37
Device B
Device C
Host A
Receiver
Host B
Figure 15. (Details not shown.)