HP A8800 Configuration Manual page 177

Router C
Router C
Router D
Router D
Router D
Router E
Router E
Router E
Router E
Configuration procedure
1. Configure the IP address and subnet mask for each interface as per
2. Configure the OSPF protocol for interoperation among the routers in the PIM-SM domain. Ensure
the network-layer interoperation in the PIM-SM domain and enable dynamic update of routing
information among the routers through a unicast routing protocol. (Details not shown.)
3. Enable IP multicast routing, PIM-SM, and IGMP:
# Enable IP multicast routing on Router A, enable PIM-SM on each interface, and enable IGMP on
GigabitEthernet 3/1/1, which connects Router A to the stub network.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface GigabitEthernet 3/1/1
[RouterA-GigabitEthernet3/1/1] igmp enable
[RouterA-GigabitEthernet3/1/1] pim sm
[RouterA-GigabitEthernet3/1/1] quit
[RouterA] interface serial 4/1/9/1:0
[RouterA-Serial4/1/9/1:0] pim sm
[RouterA-Serial4/1/9/1:0] quit
[RouterA] interface pos 5/1/1
[RouterA-Pos5/1/1] pim sm
[RouterA-Pos5/1/1] quit
# Enable IP multicast routing, PIM-SM, and IGMP on Router B and Router C in the same way.
(Details not shown.)
# Enable IP multicast routing and PIM-SM on Router D and Router E in the same way. (Details not
shown.)
4. Configure a C-BSR and a C-RP:
# On Router D, configure the service scope of RP advertisements, specify a C-BSR and a C-RP, and
set the hash mask length to 32 and the priority of the C-BSR to 10.
<RouterD> system-view
[RouterD] acl number 2005
[RouterD-acl-basic-2005] rule permit source 225.1.1.0 0.0.0.255
[RouterD-acl-basic-2005] quit
[RouterD] pim
[RouterD-pim] c-bsr pos 5/1/1 32 10
[RouterD-pim] c-rp pos 5/1/1 group-policy 2005
GigabitEthernet 3/1/1
POS 5/1/1
GigabitEthernet 3/1/1
Serial 4/1/9/1:0
POS 5/1/1
POS 5/1/1
POS 5/1/2
POS 5/1/3
POS 5/1/4
10.110.2.2/24
192.168.3.1/24
10.110.5.1/24
192.168.1.2/24
192.168.4.2/24
192.168.3.2/24
192.168.2.2/24
192.168.9.2/24
192.168.4.1/24
165
Figure 51. (Details not shown.)