HP A8800 Configuration Manual page 442

[RouterB] multicast ipv6 routing-enable
[RouterB] pim ipv6
[RouterB-pim6] c-bsr admin-scope
[RouterB-pim6] quit
[RouterB] interface GigabitEthernet 3/1/1
[RouterB-GigabitEthernet3/1/1] pim ipv6 sm
[RouterB-GigabitEthernet3/1/1] quit
[RouterB] interface serial 4/1/9/1:0
[RouterB-Serial4/1/9/1:0] pim ipv6 sm
[RouterB-Serial4/1/9/1:0] quit
[RouterB] interface pos 5/1/1
[RouterB-Pos5/1/1] pim ipv6 sm
[RouterB-Pos5/1/1] quit
[RouterB] interface pos 5/1/2
[RouterB-Pos5/1/2] pim ipv6 sm
[RouterB-Pos5/1/2] quit
# Enable IPv6 multicast routing and IPv6 administrative scoping, and enable IPv6 PIM-SM on
Router C, Router D, Router F, Router G, and Router H in the same way. (Details not shown.)
4. Configure an IPv6 admin-scoped zone boundary:
# On Router B, configure POS 5/1/1 and POS 5/1/2 as the boundary of IPv6 admin-scoped
zone 1.
[RouterB] interface pos 5/1/1
[RouterB-Pos5/1/1] multicast ipv6 boundary scope 4
[RouterB-Pos5/1/1] quit
[RouterB] interface pos 5/1/2
[RouterB-Pos5/1/2] multicast ipv6 boundary scope 4
[RouterB-Pos5/1/2] quit
# On Router C, configure POS 5/1/1 and POS 5/1/2 as the boundary of IPv6 admin-scoped
zone 2.
<RouterC> system-view
[RouterC] interface pos 5/1/1
[RouterC-Pos5/1/1] multicast ipv6 boundary scope 4
[RouterC-Pos5/1/1] quit
[RouterC] interface pos 5/1/2
[RouterC-Pos5/1/2] multicast ipv6 boundary scope 4
[RouterC-Pos5/1/2] quit
# On Router D, configure POS 5/1/1 as the boundary of admin-scoped zone 2.
<RouterD> system-view
[RouterD] interface pos 5/1/1
[RouterD-Pos5/1/1] multicast ipv6 boundary scope 4
[RouterD-Pos5/1/1] quit
5. Configure C-BSRs and C-RPs:
# On Router B, configure the service scope of RP advertisements and configure Serial 4/1/9/1:0
as a C-BSR and C-RP of admin-scoped zone 1.
[RouterB] pim ipv6
[RouterB-pim6] c-bsr scope 4
[RouterB-pim6] c-bsr 1002::2
430