HP A8800 Configuration Manual page 437

[RouterD] pim ipv6
[RouterD-pim6] c-bsr 4002::1 128 10
[RouterD-pim6] c-rp 4002::1 group-policy 2005
[RouterD-pim6] quit
# On Router E, configure the service scope of RP advertisements, specify a C-BSR and a C-RP, and
set the hash mask length to 128 and the priority of the C-BSR to 20.
<RouterE> system-view
[RouterE] acl ipv6 number 2005
[RouterE-acl6-basic-2005] rule permit source ff0e::101 64
[RouterE-acl6-basic-2005] quit
[RouterE] pim ipv6
[RouterE-pim6] c-bsr 1003::2 128 20
[RouterE-pim6] c-rp 1003::2 group-policy 2005
[RouterE-pim6] quit
Verify the configuration
# Display IPv6 PIM configuration information on Router A.
[RouterA] display pim ipv6 interface
Interface
GE3/1/1
Ser4/1/9/1:0
Pos5/5/1
# Display BSR information and the locally configured C-RP information in effect on Router A.
[RouterA] display pim ipv6 bsr-info
Elected BSR Address: 1003::2
Priority: 20
Hash mask length: 128
State: Accept Preferred
Uptime: 00:04:22
Expires: 00:01:46
# Display BSR information on Router D and the locally configured C-RP information in effect.
[RouterD] display pim ipv6 bsr-info
Elected BSR Address: 1003::2
Priority: 20
Hash mask length: 128
State: Elected
Uptime: 00:05:26
Expires: 00:01:45
Candidate BSR Address: 4002::1
Priority: 10
Hash mask length: 128
State: Candidate
Candidate RP: 4002::1(Pos5/1/1)
Priority: 192
HoldTime: 130
Advertisement Interval: 60
NbrCnt HelloInt DR-Pri
0 30 1
1 30 1
1 30 1
425
DR-Address
1001::1
(local)
1002::2
1003::2